【資料名稱】：中興1xEVDO RevA 無線參數配置說明

【資料作者】：中興

【資料日期】：2009

【資料語言】：中文

【資料格式】：DOC

【資料目錄和簡介】：

沒有目錄，但是很詳細，共345頁，絕對物超所值
3.2.51DRCLockPeriod
【字段描述】：
連續DRCLock bit發送的時間間隔。目前共有兩個取值，8Slots或16Slots
【配置約束】：
DRCLock發送的方式如下：

If the parameter is set to 1 (16 slots), the reliability of the access terminal successfully receiving the DRCLock bit is higher due to the increased time diversity. However, the latency of the DRC Lock bit change at the AT is higher. Since the RPC Channel and the DRCLock Channel are time-division multiplexed and transmitted on the same MAC Channel, a DRCLockPeriod setting of 0 (8 slots) reduces the effective RPC Channel rate. The RPC data rate is 600 × (1 − 1/DRCLockPeriod) bps.
【后臺配置位置】
ZXC10 BSSB[] -> BSSB[] -> BSCB[] -> Radio Configuration -> DO Parameters ->QoS Independent -> Airlink Protocols [Default Forward Traffic Channel MAC Protocol]

3.2.52DRCLockLength
【字段描述】：
表示DRCLock bit重復發送的次數，目前共有4/8/16/32四種取值。
【配置約束】：
DRCLockLength的使用詳見2.2.52對應的DRCLock發送時序圖。
DRCLockPeriod * DRCLockLength means the transmission duration of a DRCLock bit. Long duration maybe helpful to decoding reliability but increase the latency of the DRCLock bit change which influent the fast DRC handoff and decrease the forward link throughput. However, it will eliminate false DRC re-pointing triggers due to occasional (low probability) errors on the DRC Lock channel as to less duration.

【后臺配置位置】
ZXC10 BSSB[] -> BSSB[] -> BSCB[] -> Radio Configuration -> DO Parameters ->QoS Independent -> Airlink Protocols [Default Forward Traffic Channel MAC Protocol]

3.2.53NullRateDRC38k4En
【字段描述】：
NullRateDRC38.4Enable，表示Null速率時是否繼續以38.4K速率發包。
【配置約束】：
如果配置為1，當AT申請Null Rate時，前向仍然以38.4的速率發包。
目前缺省為0。
【后臺配置位置】
ZXC10 BSSB[] -> BSSB[] -> BSCB[] -> Radio Configuration -> DO Parameters ->QoS Independent -> Airlink Protocols [Default Forward Traffic Channel MAC Protocol]